Troubleshooting - 85
Lamp Indicator
Blinking in
Green
Warm-up in
progress
(Not an error)
·Wait for a moment.
·The amount of time required for the warm-up
procedure is approximately 30 seconds.
·The green lamp will stop blinking and
become illuminated once the warm-up
procedure has been completed.
42
Illuminated in
Red
Internal error Cease operations, remove the Power Plug from
the socket and contact your dealer or nearest
address provided at page 107 and request
repairs.
Extinguished The power is not
switched on
The power is not switched on.
·Check the power cord connection.
·Check the power supply to the socket.
42
Indicator Status Cause Recovery and Status Reference
Page
Blinking in Red Lamp error ·Replace with a new lamp (ELPLP11).
·If the lamp is broken, take care to avoid injury
and contact your nearest address provided at
page 107 to request repairs (images cannot be
projected unless the lamp is replaced).
·Check to ensure that the lamp or fan are
correctly attached if the lamp has been
replaced. If the lamp or fan are not correctly
attached, the projector will assume the same
status as if the power has not been switched
on.
97
Blinking in
Orange
Nearing the time
for replacing the
lamp
Prepare a new lamp. It is recommended that
the lamp is replaced as soon as possible, as
there are cases where the time for replacement
is earlier than stated in the conditions of usage.
97
Extinguished (Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Indicator Status Cause Recovery or Status Reference
Page
