2. At the OpenVMS command line (DCL) issue the @SYS$SYSTEM:SHUTDOWN command and
specify the shutdown options in response to the prompts given.
>@SYS$SYSTEM:SHUTDOWN
SHUTDOWN -- Perform an Orderly System Shutdown
on node RSNVMS
How many minutes until final shutdown [0]:
Reason for shutdown [Standalone]:
Do you want to spin down the disk volumes [NO]?
Do you want to invoke the site-specific shutdown procedure [YES]?
Should an automatic system reboot be performed [NO]? yes
When will the system be rebooted [shortly via automatic reboot]:
Shutdown options (enter as a comma-separated list):
REBOOT_CHECK Check existence of basic system files
SAVE_FEEDBACK Save AUTOGEN feedback information from this boot
DISABLE_AUTOSTART Disable autostart queues
POWER_OFF Request console to power-off the system
Shutdown options [NONE]:
%SHUTDOWN-I-OPERATOR, this terminal is now an operator’s console
...
NOTE: HP OpenVMS I64 currently does not support the POWER_OFF shutdown option.
The SYS$SYSTEM:SHUTDOWN.COM command prompts establish the shutdown behavior,
including the shutdown time and whether the system is rebooted after it is shut down.
• To perform a reboot for reconfig from OpenVMS I64 running on an nPartition, issue
@SYS$SYSTEM:SHUTDOWN.COM from OpenVMS, and then enter Yes at the “Should
an automatic system reboot be performed” prompt.
• To perform a shutdown for reconfig of an nPartition running OpenVMS I64:
1. Issue @SYS$SYSTEM:SHUTDOWN.COM from OpenVMS and enter No at the “Should
an automatic system reboot be performed” prompt.
2. Access the management processor and, from the management processor Command
Menu, issue the RR command and specify the nPartition. The nPartition you specify
will be put in the shutdown for reconfig state.
Booting and Shutting Down Microsoft Windows
This section presents procedures for booting and shutting down the Microsoft Windows OS on
cell-based HP Integrity servers and a procedure for adding Windows to the boot options list.
• To determine whether the cell local memory (CLM) configuration is appropriate for Windows,
refer to “Microsoft Windows Support for Cell Local Memory” (page 133).
• To add a Windows entry to the boot options list, refer to “Adding Microsoft Windows to
the Boot Options List” (page 134).
• To boot Windows, refer to “Booting Microsoft Windows” (page 135).
• To shut down Windows, refer to “Shutting Down Microsoft Windows” (page 137).
Microsoft Windows Support for Cell Local Memory
On servers based on the HP sx2000 chipset, each cell has a cell local memory (CLM) parameter,
which determines how firmware interleaves memory residing on the cell.
Booting and Shutting Down Microsoft Windows 133
