Turbonetics P/N 15152 Manual

A SERVICE OF

next previous

60133 revG Page 10 of 38

3. Remove the factory exhaust head shield by unscrewing the three 12mm bolts and one 12mm nut. SEE

FIGURE 13 & 14

FIGURE 13 FIGURE 14

Note: Careful while removing the heat shield, it tends to get caught up with the O2 sensor and other things in

the area.

4. Unscrew the O2 sensor with a 7/8” open end wrench or with a O2 sensor socket. SEE FIGURE 15

FIGURE 15

5. Using a 14mm socket, remove the stock catalytic converter support brackets. SEE FIGURE 16 & 17

FIGURE 16 FIGURE 17