A SERVICE OF

logo

Open as PDF
next previous
60133 revG Page 30 of 38
FIGURE 80
Connecting the Signal Line to the Blow of Valve and Wastegate
1. Install 1/8”NPT to 5/32” barb fitting (P/N #30306) to the TOP port in the top cover of the blow off valve.
Apply a small amount of thread sealant. SEE FIGURE 81
FIGURE 81
2. Cut the supplied 5/32” vacuum tubing (P/N #30542-BK) to length and connect the fitting on the blow off
valve to the t-fitting by the throttle body. Next, connect the vacuum hose from the fitting on the turbo
compressor housing to the fitting on the wastegate.
Re-Installing the Front Fascia
1. Remove the lower bumper grill by popping it out from the back of the bumper. SEE FIGURE 82
FIGURE 82