Turbonetics P/N 15152 Manual

A SERVICE OF

next previous

60133 revG Page 13 of 38

6. Remove the sensor that is mounted to the factory intake tube by inserting a small flat head screwdriver

between the sensor bracket and the intake tube bracket. SEE FIGURE 24

FIGURE 24

7. Remove the factory air box by unbolting the three 10mm bolts inside. SEE FIGURE 25

FIGURE 25

8. Remove the factory cold air intake tube by unscrewing the Phillips screw that mounts the factory cold air

intake tube to the body. There is another Phillips screw that holds the tube to the body, that screw does

not need to be removed, the tube bracket slides underneath that screw only. SEE FIGURE 26

FIGURE 26