Turbonetics P/N 15152 Manual

next previous

60133 revG Page 28 of 38

FIGURE 72

11. Install the rubber o-ring (P/N #30468) into the groove of the blow off valve flange and install the Raptor

blow off valve to the flange using the supplied ¼-20 x 5/8 serrated bolts (P/N #30248). Make sure the o-

ring remains in its groove. Rotate the valve so it facing toward the front of the vehicle. Slide the supplied

1.50” diameter silicone hose (P/N #30172-4) onto the discharge of the valve. Secure using band clamps

(P/N #30612).

12. Attach the turbo to air filter pipe assembly onto the turbo inlet using the supplied 3.0” silicone hose

coupling (P/N #30162-4). Secure the pipe using 3.0” t-bolt clamps (P/N #30275-300). While installing the

pipe assembly to the turbo, slide the blow off valve re-circulation tube into the silicone hose you

previously installed on the discharge of the valve. SEE FIGURE 73 & 74 Secure the mount on one end

of the intake tube to the rubber isolator previously installed using the supplied nylon lock nut (P/N

#30586). SEE FIGURE 75

FIGURE 73 FIGURE 74

PIPE P/N #21238

SIDE TO

AIR FILTER

BOV RE-CIRC

TUBE