A SERVICE OF

logo

60133 revG Page 15 of 38
6. Remove stock fuel injectors from the fuel rail. Careful not to lose any of the o-rings when removing them.
7. Connect the new supplied injector pig tails to the factory harness by cutting the stock injector connector
plugs off the factory harness. Cut wires around 2 ¾” from the edge of the connector, leaving enough wire
length to connect the new plugs. SEE FIGURE 31
FIGURE 31
8. Crimp the new supplied connectors to the factory harness. Make sure the polarities are correct. SEE
FIGURE 32 & 33
a. Wires colored blue, red, yellow, and white are positive (+)
b. Wires colored black are negative (-)
FIGURE 32 FIGURE 33