5–4
SCANTEAM 3700 Wedge Technical Manual
You are using anIBM PC AT and are scanning a UPC A bar code with afive digit
addenda (shown below). The bar code has a total of 18 characters, including
the number system, the check digits, and a space between the main bar code
data and the addenda bar code data.
Data Formatter Example
H Scan the Enter Data Format bar code (page 5-2).
H Scan the 03 bar codes (inside back cover) for PC AT Terminal Type.
For your application, you don't want the space between the main bar codedata
and the addenda bar code data transmitted. You also want the bar code data
followed by a carriage return (CR).
UPC A with 5 digit addenda
56098
0 12345 67890 5
Using the programming bar codes on pages 5-2 and inside back cover, and
referring to the Format Editor Commands Chart on page 5-3; scan the
following to format the bar code data for your application:
H Scan the 63 bar codes (inside back cover), the Hex value for UPC
symbology.
H Scan the 18 bar codes (inside back cover) for the bar code length[.
H Scan the FB (suppress characters command) bar codes (inside back
cover), scan 20 (the Hex value for a space), and then scan FB to frame
(complete) the command.
H Scan the FF bar codes (inside back cover) to end Format Editor
selection.
(The following are the Editor Command Sequences:)
H Scan the F7 bar codes (inside back cover) to move the cursor back to
the beginning of the bar code data.
[ The bar code length includes all spaces.
H Scan the F1 and 0D bar codes (inside back cover) to send all the
characters followed by a carriage return (CR= 0D in Hex value).
