6–12
SCANTEAM 3700 Wedge Technical Manual
Message Length
Check Digit
Programming Tip: If a symbology won't be used, we recommend turning it off
to minimize the chance of a misread.
If the application requires the ability to read variableĆlength messages, or some
other fixedĆlength, then choose the minimum and Maximums accordingly. We
recommend setting therange [Minimum,Maximum] assmall asthe application
allows. Defaults on default chart at the end of this manual.
Bearer bars having a width comparable to the wide elements can be printed to
further enhance security.
Use of a check digit is optional in Interleaved 2 of 5. For applications requiring
enhanced security, symbols should be printed with a check digit using the
format described in the AIM specification, and the reader should be
programmed to verify its value. Since it is not considered part of the message
the check digit is not ordinarily transmitted, though the reader can be
programmed to transmit it. Default = No Check Digit.
Note: To select digits 0 through 9 use the Programming Chart found on the
inside of theback cover of thismenu. Scanthe programmingselection bar code
first, and then scan the bar code(s) representing the digits you wish to set.
Interleaved 2 of 5
123456
Bearer Bars
Message
Length
Maximum ]Minimum ]
Validate, But Don't Transmit
✱ No Check Digit
Validate, And Transmit
] A twoĆdigit number is required after scanning this programming bar code.
Please scan your selection on the Programming Chart (inside back cover).
Programming Tip: If a symbology won't be used, we recommend turning it off
to minimize the chance of a misread.
