Prestige 201 ISDN Access Router
2-8 Hardware Installation & Initial Setup
Figure 2-7 Booting Up the Prestige
Follow the procedure below to upload the configuration file:
1. Enter “atlc” after the “Enter Debug Mode” message.
2. Wait for the “Starting XMODEM upload” message before activating Xmodem upload on your
terminal.
3. After successful firmware upload, enter “atgo” to restart the Prestige.
The Prestige is now reinitialized with default configuration file including the default password of 1234.
2.8.1 Filename conventions
The configuration filename is the router model name with a rom extension, e.g., p201.rom. The ZyNOS
firmware filename is the router model name with a bin extension, e.g., p201.bin. Rename the latter filename
to “ras” when uploading to the Prestige.
Bootbase Version: V1.03 | 3/18/1999 15:04:51
RAM: Size = 4096 Kbytes
FLASH: intel 8M
ZyNOS Version: V2.30a00 | 5/5/1999 9:37:32
Press any key to enter debug mode within 3 seconds.
........................................
Enter Debug Mode
atlc
Now erase flash ROM for upload……
Programming successful…
OK
