Prestige 201 ISDN Access Router
System Maintenance 8-11
Test This command triggers the Prestige to perform a loop-back test to check the
functionality of the ISDN line. If the test is not successful, note the error
message that you receive and consult your network administrator.
Manual Call This provides a way for you to place a call to a remote node manually. This
tests the connectivity to that remote node. When you use this command, the
screen displays what is happening during the call setup and protocol
negotiation. Below is an example of a successful connection.
Internet Setup
Test
This test checks to see if your Internet access configuration has been done
correctly. When this option is chosen, the Prestige places a manual call to the
ISP remote node. If everything is working properly, you will receive an
appropriate response. Otherwise, note the error message and consult your
network administrator.
Ping Host This diagnostic test pings the host, which determines the functionality of the
TCP/IP protocol on both systems and the links in between.
Reboot System This option reboots the Prestige.
Command Mode This option allows you to enter the command mode. This mode allows you to
diagnose and test your Prestige using a specified set of commands.
The following figure shows an example of a successful connection after selecting option Manual Call in
Menu 24.4.
Figure 8-10 Display for a Successful Manual Call
Start dialing for node <1>
### Hit any key to continue. ###
Dialing chan<2> phone<last 9-digit>:12345
Call CONNECT speed<64000> chan<2> prot<1>
LCP up
CHAP send response
CHAP login to remote OK!
IPCP negotiation started
IPCP up
