Prestige 201 ISDN Access Router
2-12 Hardware Installation & Initial Setup
Field Description
PABX Number (Include
S/T Bus Number)
The PABX number is used for an outside loopback test when the ISDN PABX
cannot support a local loopback test. If the Prestige is connected to an ISDN
PABX enter this number. Note that this number is used exclusively for
loopback testing; for regular outgoing calls, the Prestige dials the phone
number in the remote node. If this field is blank it indicates either that the
PABX supports local loopback testing or that the Prestige is not connected to a
PABX.
Outgoing Calling Party
Number
ISDN Data If this field is not blank, the Prestige will use its value as the calling party
number for "ISDN Data" outgoing calls. Otherwise, the individual entry for
"ISDN Data" in Menu 2.1 will be used as the calling party number. You only
need to fill in this field if your switch or PABX requires a specific calling party
number for outgoing calls; otherwise, leave it blank.
Data Link Connection
Use the space bar to choose either ISDN point-to-point or point -to-
multipoint data link connection. The default is point-to-multipoint.
Note: You must have obtained the data link connection mode supported by
your Telco when subscribing for the ISDN line. If not, ask your Telco and
select the supported mode here.
The following diagram illustrates the PABX Number (with S/T Bus Number) for Loopback and Outgoing
Calling Party Number fields for a Prestige behind an ISDN PABX.
Figure 2-11 Prestige behind a PABX
