A SERVICE OF

logo

Prestige 201 ISDN Access Router
2-16 Hardware Installation & Initial Setup
Figure 2-14 Menu 2.2 - NetCAPI Setup
Set the fields in the above menu according to the following description.
Table 2-6 NetCAPI Setup Fields
Field Description
Active This field allows you to enable or disable NetCAPI. Press the [Spacebar] to toggle
between Yes and No
Max Number of
Registered Users
When you want to use NetCAPI to place outgoing calls or to listen to incoming calls,
you must start RVSCOM on your workstation, and RVSCOM will register itself to the
Prestige. This option is the maximum number of clients that the Prestige supports at the
same time. The default value is 4.
Incoming Data
Call Number
Matching
This field will be removed in future release. Now it has fixed value of NetCAPI.
Access List This list specifies users that can use NetCAPI. This access list controls if a client is
allowed to use NetCAPI. The request is rejected when
1. The IP address of the workstation is not between Start IP and End IP or
2. The request from the workstation is not permitted as specified in the
Menu 2.2 - NetCAPI Setup
Active= Yes
Max Number of Registered Users= 1
Incoming Data Call Number Matching= NetCAPI
Access List:
Start IP End IP Operation
192.168.1.132 192.168.1.145 Both
192.168.14.1 192.168.14.32 Imcoming
192.168.20.7 192.168.20.12 Outgoing
192.168.30.1 192.168.30.3 Both
10.0.0.0 10.255.255.255 Incoming
_______________ _____________ _______
_______________ _____________ _______
_______________ _____________ _______
default Both
Press ENTER to Confirm or ESC to Cancel: