Prestige 201 ISDN Access Router
Hardware Installation & Initial Setup 2-17
Operation field.
Start IP Refers to the first IP address of a group of NetCAPI clients. Each group contains
contiguous IP addresses.
End IP Refers to the last IP address in a NetCAPI client group.
Operation Press the [Spacebar] to select Incoming if you wish to grant incoming calls permission.
Select Outgoing if you wish to grant outgoing calls permission. Select
Both if you wish to grant both incoming calls and outgoing calls permissions. Select
None if you wish to deny all calls.
2.11 Ethernet Setup
This section describes how to configure the Ethernet using Menu 3 – Ethernet Setup. From the Main
Menu, enter 3 to open Menu 3.
Figure 2-15 Menu 3 - Ethernet Setup
2.11.1 General Ethernet Setup
This menu allows you to specify filter set(s) that you wish to apply to the Ethernet traffic. You seldom need
to filter Ethernet traffic; however, the filter sets may be useful to block certain packets, reduce traffic and
prevent security breaches.
1. General Setup
2. TCP/IP and DHCP Setup
Enter Menu Selection Number:
