Chapter 7 Wireless
VSG1435-B101 Series User’s Guide
111
Click Network Settings > Wireless > WMM. The following screen displays.
Figure 33 Network Settings > Wireless > WMM
The following table describes the labels in this screen.
7.7 The WDS Screen
An AP using the Wireless Distribution System (WDS) can function as a wireless
network bridge allowing you to wirelessly connect two wired network segments.
The WDS screen allows you to configure the ZyXEL Device to connect to two or
more APs wirelessly when WDS is enabled.
Use this screen to set up your WDS (Wireless Distribution System) links between
the ZyXEL Device and other wireless APs. You need to know the MAC address of
the peer device. Once the security settings of peer sides match one another, the
connection between devices is made.
Note: WDS security is independent of the security settings between the ZyXEL
Device and any wireless clients.
Note: At the time of writing, WDS is compatible with other ZyXEL APs only. Not all
models support WDS links. Check your other AP’s documentation.
Table 18 Network Settings > Wireless > WMM
LABEL DESCRIPTION
WMM Select On to have the ZyXEL Device automatically give a service a
priority level according to the ToS value in the IP header of packets it
sends. WMM QoS (Wifi MultiMedia Quality of Service) gives high priority
to voice and video, which makes them run more smoothly.
WMM Power
Save
Select this option to extend the battery life of your mobile devices
(especially useful for small devices that are running multimedia
applications). The ZyXEL Device goes to sleep mode to save power when
it is not transmitting data. The AP buffers the packets sent to the ZyXEL
Device until the ZyXEL Device "wakes up". The ZyXEL Device wakes up
periodically to check for incoming data.
Note: Note: This works only if the wireless device to which the
ZyXEL Device is connected also supports this feature.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
