AT&T 2 Cell Phone User Manual


 
Connecting to the Internet
Your phone’s impressive networking capabilities allow you to access the Internet
or your corporate network with ease. You can use default connection settings to
connect to the web via your mobile network (GPRS/EDGE/3G) or Wi-Fi. The GPRS/
EDGE/3G connection can be enabled/disabled manually. From the home screen,
press > System settings > Mobile networks and check or uncheck the Data
enabled check box.
Adding a New GPRS/EDGE/3G Connection
To get connected via GPRS/EDGE/3G, you need a data plan with your service
provider. If the GPRS/EDGE/3G settings are not pre-configured on your phone,
please contact your provider to get the necessary information.
 From the home screen, press
> System settings > Mobile networks >
Access Point Names.
Press
> New APN.
 Tap each item to enter the information you receive from your service provider.
Tap Save to complete.
Tip: To set the APN to default settings, press
> Reset to default.
Turning on Wi-Fi
Wi-Fi provides wireless Internet access over distances of up to 300 feet
(90 meters).
From the home screen, press
> System settings and then slide the Wi-Fi
switch to the On position.
30 Connecting to the Internet 31Connecting to the Internet
Connecting to a Wi-Fi Network
 From the home screen, press > System settings > Wi-Fi. The Wi-Fi
network points, or “hotspots,” that your phone has detected are displayed
with their names and security settings.
 Tap a network to connect to it. If security features are implemented, you’ll need
to enter a password and then tap Connect.
 To disconnect from a network, tap the network name and then tap Forget.
Checking the Wi-Fi Network Status
You can check the Wi-Fi network by looking at the icon in the status bar. Or, tap
the network the phone is currently connected to on the Wi-Fi screen. You can then
check the network status from the pop-up window.