AT&T CU405 Cell Phone User Manual


 
19
Getting Started
n
Warning
The travel charger must be unplugged before you remove
the battery, otherwise, the phone could be damaged.
3. When charging is finished, disconnect the travel
charger from the phone by pressing on the grey tabs
on both sides of the connector while pulling the
connector out.
n
Note
]If your phone is powered on while charging, you’ll see the
bars on the battery indicator icon cycle.
]While a phone is being charged, ‘Charging..’ message is
shown in the idle screen.
]When it is completed, ‘Charge complete’ message is
displayed in the same place.
If a user cannot see the ‘Charge complete’ message, even
if battery icons are show 3 blocks, it means the phone is
not charged fully yet.
If the battery fails to charge completely:
]After turning the phone on and off, please attempt to
recharge the battery.
]After detaching and reattaching the battery, please
attempt to recharge the battery.
Turning Your Phone On and Off
1. Hold down the [END] key until the phone
switches on.
2. If the phone asks for a PIN, enter the PIN and press
the key.
The phone searches for your network and after finding
it goes to the idle screen as illustrated below. From the
idle screen, you can make or receive a call.