Filter
Top Products
9
Wiring Instructions
1. Remove the wiring access doors by removing the two Phillips head
screws that secure them.
2. Determine which of the two available conduit entry points are to
be used. Knock out the conduit entry hole for the location and size
of conduit to be used.
3. Connect conduit bushing and conduit and run utility load wiring.
Inspect wiring to ensure it is not pinched. Make connections to the
terminal blocks as labeled. The wiring terminals are labeled.
4. Close the wiring access doors and install the retaining screws.
CAUTION:
To
reduce the risk of fire, connect o
nly to a
circuit provided w
ith 15 am
pe
res m
axim
um
branch circuit overcurrent prote
ction
in
accordance w
ith the Nationa
l Electric Code
A
NSI/N
FPA 70.
Input
14-12AWG 8Kgf-cm
L
N
Left Side of POD
Knockouts
for Conduit
Input Terminal
Block Connections
Output
14
-12
A
W
G
8K
g
f-c
m
L
N
Right Side of POD
Output Terminal
Block Connections
Knockouts
for Conduit
CAUTION - RISK OF ELECTRIC SHOCK, SO NOT REMOVE COVER. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION - RISK OF ELECTRIC SHOCK, THIS UPS RECEIVES POWER FROM
MORE THAN ONE SOURCE-DISCONNECTION OF THE AC SOURCES IS REQUIRED
TO DE-ENERGIZE THIS UNIT BEFORE SERVICING.
CAUTION - FOR USE IN A CONTROLLED ENVIRONMENT. REFER TO MANUAL FOR
ENVIRONMENTAL CONDITION.
Model No. : MP2-115HW
Desc. : Micro Pod
Input : 120VAC 12A
50/60Hz, 10
Ouptut : 120VAC 12A
50/60Hz, 10
MADE IN TAIWAN 612-XXXXX-00
C US
LISTED
91N6
U.P.S. Accessory
U
L
Extract screws to remove
wiring access doors