Filter
Top Products
11
START EQUIPMENT
1. Turn on all loads hardwired to the output of the POD. The 2U
POD now powers your equipment in the UTILITY mode.
2. Turn ON the loads and ensure all are up and operating properly.
3. Start the UPS according to its specific user manual.
4. Verify that the UPS lamp (green) on the 2U POD is illuminated. If
so, transfer the rotary switch from UTILITY to UPS. The load is
now being supplied with conditioned power through the UPS.
5. Before any operation or procedure, always verify that both the
UPS lamp (green) and the UTILITY lamp (amber) are illuminated
before changing the status of the rotary switch.