Ericsson LBI-38965B Cell Phone User Manual


 
LBI-38965 INSTALLATION
32
USER ACTION: If either of the previous commands were executed, you can verify them by entering the
following command. The previous two steps may be repeated in case the values were incorrectly entered by the
operator.
BCS> show system /nim /pim
NIM slot = 32
PIM slot = 16
USER ACTION: Exit BCS, which returns the operator the pSH+> prompt.
BCS> exit
pSH+>
4.2.2.2. System Disk Booting
After software has been installed on the BCU/CAL system disk, the BCU/CAL will use these files for any subsequent
(re)boot. The following example shows the typical console output observed when the BCU/CAL boots from its hard disk.
No user action is required for this process. The BCU/CAL will immediately begin normal application processing when the
boot cycle is complete.
<OS> Beginning bootstrap loader: DATE: May 4, 1994 TIME: 1:56:23 pm
<OS> Scanning hard disk for LOADER.SX...
<OS> Loading file LOADER.SX from the hard disk... *
<OS> Load complete. 97762 bytes loaded.
<OS> Hard disk has been unmounted.
<OS> Transferring program control to LOADER module...
<LOADER> Installing BCU/CAL: DATE: May 4, 1994 TIME: 1:56:58 pm
<LOADER> Processing file 01.02/cnfg/IP.DAT.
Setting IP address: 147.117.37.226 (0x937525E2)
Assigning host name: bcu01
Setting subnet mask: 0xFFFFF000
<LOADER> Loading file 01.02/loads/BC_A.SX from the hard disk... *
<LOADER> First load complete. 393126 bytes loaded.
<LOADER> Loading file 01.02/loads/BC_B.SX from the hard disk... *
<LOADER> Second load complete. 55692 bytes loaded.
<LOADER> Application load complete. 448818 bytes loaded.
<LOADER> Hard disk has been unmounted.
<LOADER> Transferring program control to BCU/CAL...
<BCU/CAL> System startup: Wed May 4 13:58:32 1994
<BCU/CAL> Beginning boot of fv5310 WanServer board...
<BCU/CAL> WanServer boot complete.
<BCU/CAL> Initializing memory and global objects...
<BCU/CAL> Beginning application installation...
<BCU/CAL> Checking system directories.
<BCU/CAL> Checking system configuration files.
<BCU/CAL> Checking product feature license.
<BCU/CAL> Application installation complete.