Filter
Top Products
Not for commercial use – Ericsson Inc.
Getting Started 11
result, the phone may not activate charge-only mode
when the charger is connected.
1
Attach the charger to the phone for several hours to
slowly (trickle) charge the battery.
2
After trickle charging the battery for several hours
the phone should activate the charge-only mode
automatically.
3
Continue charging the phone until the battery is
fully charged.
Note! If the phone is powered On, the battery icon is replaced
by the icon once the battery is fully charged.
Note! If the phone is in charge-only mode, Charging Com-
plete appears in the display when the battery is fully
charged.
Selecting Your Charger
Your phone is packaged with one of the following bat-
tery chargers:
• Rapid charger
• Travel charger
• Desktop charger
Rapid Charger
The rapid charger supplies power
to charge your battery while the
battery is attached to your phone.
If your phone is On, it can receive
calls while using the rapid charger.
To charge your battery using the
rapid charger:
1
Plug the charger into a standard
wall electrical outlet.
2
Hold the phone with the dis-
play and keypad facing up.
3
Hold the small plug on the
charger cord so the lightning
bolt symbol is up.
4
Align the small plug on the
charger cord with the connec-
tor on the bottom of your phone. The connector on
the phone is above the lightning bolt symbol.
Note! Do not twist while inserting or removing the small
plug on the charger cord!
5
Press the plug into the connector until the plug
“snaps” into place.
Note! To disconnect the charger, lift the plug connected to the
phone upwards and pull it out.