Filter
Top Products
Not for commercial use – Ericsson Inc.
64 Data, Fax, and Internet Calls
2
Connect one end of your serial cable to your Erics-
son mobile phone and the other end to your com-
puter’s serial port.
3
From the Start menu on your Windows desktop,
click on Settings, then Control Panel. Double-click
the Modems icon.
4
Click Add.
5
At the Install New Modem screen, select Other.
Click Next.
6
At the next Install New Modem screen, select Don’t
run Hardware Installation Wizard then click Next.
7
At the next Install New Modem screen, select Don’t
detect my modem, I will select it from a list then
click Next.
8
At the next Install New Modem screen, click on
Have Disk.
9
At the Install from Disk screen, select D:\ at Copy
from Manufacturer’s Disk (if your CD-ROM drive
is not drive D, type the correct CD-ROM drive des-
ignation).
10
At the Install New Modem screen, select Ericsson
Voice Call Dialer, then click Next.
11
Select the COM port to which your Ericsson mobile
phone is connected and click Next.
12
When Your modem has been set up successfully
appears, click Finish.
13
When your desktop returns, verify that your modem
is properly installed. From the Start menu, click on
Settings, then Control Panel. Double-click the
Modems icon.
14
When the Modem Properties screen appears, click
on the description of your modem and click the
Diagnostics tab. Note the COM port to which your
modem is assigned.
15
Click OK to proceed.
Troubleshooting
1
You cannot set up or maintain a data/fax session.
This will occur if you are inadvertently originating a
voice call when attempting a data/fax call or if the
data/fax profile icon does not appear on your
phone’s display after you attempt to dial or answer a
data/fax call. To correct the problem, do the follow-
ing:
a From the Start menu on your Windows desktop,
click on Settings, then Control Panel.
b Double-click the Modems icon.
c Select the General tab.
d Select Ericsson TDMA Data/Fax Modem from
the pull-down list.
e Click Properties.
f Click General. Make sure that the maximum
speed is set to 19200.
g Select the Connection tab.
h Click Advanced.
i In the Extra settings box, type the following:
+COS=4,1,2,0; +ES=1,0,1; +DS=0,0,512,6;