Filter
Top Products
Getting Connected 131
Notes
• Wi-Fi connects to the default network that is available on your phone. However,
GPRS/EDGE starts by default if your phone does not detect any Wi-Fi signal.
• In Comm Manager, select Settings > Wi-Fi > Connection Status to check the
current connection status and signal quality of each Wi-Fi channel.
• Configure your phone so that the Wi-Fi function turns off automatically when
no signal is detected to conserve battery power. In Comm Manager, select
Settings > Wi-Fi > Wi-Fi Networks > Menu > Wi-Fi Settings.
To create a new Wi-Fi connection
If the Wi-Fi connection you want to connect to is not in the list, you can
create a new Wi-Fi connection.
1. On the Home screen, select Start > Settings > Connections >
Wi-Fi Settings > Wi-Fi Networks > New.
2. Enter the Network name and Network type and select Next.
Note If you want only to connect directly to another device or computer, and
not to a network through an access point, select This is a device to
device (ad-hoc) connection.
3. Select the Authentication type and Data encryption, then select
Next.
Default settings are:
Authentication = Open ; Data Encryption = WEP
For TKIP, AES, or WEP data encryption, enter the needed information
in the remaining fields, then select Next.
4. Select Use IEEE 802.1x network access control to use Extensible
Authentication Protocol (EAP). Select the EAP type depending on the
type of authentication. Select Finish.