Filter
Top Products
User Guide for the Kyocera KX9a Phone 1
1GETTING ST ARTED
Installing the battery
Your Kyocera KX9a phone comes with a
removable lithium ion (LiIon) battery.
Fully
charge the battery before using the phone.
To install the battery:
1. Hold the phone face
down.
2. Toward the bottom of the
phone there is a recess
to aid you in opening the
battery door. Use your
fingernail to pull the
battery door away.
3. Place the battery in the
phone casing with the
metal contacts toward
the bottom of the phone.
4. Place the battery door
tabs in the openings near
the top of the phone.
5. Press the battery door
until it clicks into place.
Note: Before you remove
the battery, make sure the
phone is powered off.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter
to the jack on the bottom
of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the screen tells you whether
the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Note: The battery will not charge if you use the
phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
82-N8271-1EN.book Page 1 Wednesday, September 14, 2005 2:53 PM