Filter
Top Products
97
WIRELESS/REMOTE OFF-CAMERA FLASH
96
This camera is equipped with a PC connector which enables you
to connect PC-capable flash units with a flash sync cord.
Set the exposure mode to M,
then set the shutter to 1/200
or slower.
• Turn the flash unit off before
connecting the sync cord to the PC
terminal or the flash unit may fire
unexpectedly while connecting.
• Your camera's PC terminal is center-positive; the most common polarity
used for PC connections.
• Flash units with an extremely low trigger voltage may not work with the
800si. If your flash has a low trigger voltage, contact a Minolta Service
Facility.
• When used with the Vertical Control Grip VC-700 (sold separately) both
the camera’s PC terminal and the VC-700’s PC terminal can be used
(together or separately).
PC TERMINAL
CANCELLING THE WIRELESS/REMOTE FLASH
Attach the accessory flash to
the camera and turn the
camera and flash on.
Press the flash-mode button
in the control panel.
Turn either dial to select
another flash mode, then
press the shutter-release
button partway down to enter
the selection.
Follow the instructions for wireless/remote (p 94), but press the
flash-compensation button before taking the picture. The built-in
flash will also fire and the flash ratio will be 2:1. The built-in flash
will provide 1/3 of the exposure and the accessory flash will
provide 2/3 the exposure.
WIRELESS/REMOTE RATIO FLASH
2152EE 17/10/97 10:59 AM Page 96