Filter
Top Products
105
CUSTOMIZED SETTINGS
104
Press the shutter-release button partway down to enter
the selections.
• Turning the camera off or removing the batteries will not affect the
Customized Function Settings.
Note: When Customized Function #15 - Eye-start Switch is on
setting 2 or 3, the dials are completely disabled when the switch
is set to ON. In this case, the only function the dials will operate
is the Customized Setting.
RESETTING ALL THE CUSTOMIZED SETTINGS TO 1
Press and hold the adjust
button in the control panel.
Slide the main switch to LOCK
then return it to ON.
• When the operation is complete,
will blink in the data panel and every
custom setting will be set to 1.
✎ Release Priority is the only customized function that can be set in
memory. It is also the only customized function that can be changed by
the memory-recall button and program-reset button.
CHANGING THE CUSTOMIZED SETTINGS
While pressing the adjust
button, press the ISO button.
Turn the front dial to select the
number of the Customized
Function.
• In the example: Customized
Function #3 - Film Tip has been
selected.
Turn the rear dial to change
the setting.
• In the example: Setting 2 - (leaving
the film tip out of a rewound
cartridge) has been selected.
• Repeat steps 2 and 3 until all the desired functions are selected.
All customized settings were set to1 before your camera was
shipped.
2152EE 17/10/97 11:00 AM Page 104