Filter
Top Products
GB 21
Channel search
The Channel search procedure can be carried out in different
ways.
The menu will look different depending on what option you se-
lected in the “Antenna/satellite selection” menu.
If you selected “One antenna/one LNB configuration”, select
“Automatic”, “Manual” or “Advanced Manual” search.
If you selected “Multisatellite/DiSEqC switch configuration” or
“Motor antenna configuration” you also indicate which satellite
you wish to search from, using the cursor left/cursor right but-
ton.
Automatic search
If you selected “One antenna/one LNB configuration” or
“Multisatellite/DiSEqC switch configuration”:
•Press select to start searching for channels.
If you selected “Motor antenna configuration”:
• Select a predefined channel and then adjust the motor (if nec-
essary) using the cursor left/cursor right button.
•Press select to start searching for channels.
Manual search
The information that must be entered in this menu is available in
satellite TV magazines or on the Internet.
Transponder frequency: Specify the frequency in MHz using the
numeric buttons. If you enter the wrong value, erase using cur-
sor left.
Polarisation: Select Horizontal, Vertical, Circular left or Circular
right.
Symbol rate: Enter using the numeric buttons. If you enter the
wrong value, erase using cursor left.
Network search: Select “Yes” if you want to search all trans-
ponders that are connected to a specific network.
Adjust motor: This alternative is only visible if you have set the
motor antenna configuration. If necessary, adjust the motor for
the current satellite.
•Press select to start searching for channels.
Video, Audio and PCR PID
These alternatives are only available if you are searching from a
user-defined satellite. By entering these values you can see a TV
picture on the screen which may help you to adjust the dish.
Remove limits
If you need to remove the limits.
When you activate this command, the motor will turn itself to the
0° (Zero) position.
However, the next time you select a channel, the motor will turn
to its proper position.
First time installation