Filter
Top Products
Section 2K: Additional Features 120
7. To review, change, or delete the voice command, press
Options, scroll to select the action, and press Select.
To use voice commands:
1. From the standby mode, press and hold the key for two
seconds. (The key is below Contacts.)
2. Speak your command after the beep. (If a voice match is found,
the phone executes the command.)
Selecting Radio Stations
You can use the automatic tuning feature to scan for available local
stations, you can program specific stations into your radio, or you
can change stations using voice commands.
To scan for stations:
1. From the standby mode, press Menu, scroll to Radio, and
press Select.
2. Press Options, scroll to Automatic tuning, and press Select.
3. Press or . (The radio will scan up or down in frequency
and stop when the next station with a strong signal is found.)
To program stations:
You can program 20 stations into your radio, then scroll through
them to select one for listening.
1. From the standby mode, press Menu, scroll to Radio, and
press Select.
2. Press Options, scroll to Manual tuning, and press Select.
3. Press or to select the frequency of a radio station and
press OK.
4. Press Options, scroll to Save channel, press Select, enter a name
for the channel, and press OK.
5. Scroll to a channel position and press Select to assign the
channel to this location.
6. To program more channels, repeat Steps 2–5 until finished
with your programming.
Note:
To use voice commands to operate the radio, the radio must be on and
the phone in the standby mode.