Filter
Top Products
Base Unit Settings
172 For assistance, please visit http://www.panasonic.com/help
Note:
LYou need to register the handset to the base unit again when you change the security
mode, the network key and/or the key index.
See “Registering the handset” on page 133.
LWhen you use WEP for the network key, set either the Network Key No. 1, No. 2, No. 3
or No. 4 as a key index according to the setting of the wireless LAN card you use. When
you do not use WEP, you are suggested to use WPA-PSK/WPA2-PSK as the security
mode.
MAC Address Filtering:
This feature allows you to configure the MAC address filtering settings so that devices
without the particular MAC address will be filtered.
MAC address filtering is available only for wireless devices. Up to 5 entries can be
registered. The first entry is reserved for the handset.
To enable or disable MAC address filtering feature:
1 Click [Advanced Setup] on the Top Menu.
2 Click the [Wireless] tab, then click [MAC Address Filtering].
WP1050.book Page 172 Wednesday, November 22, 2006 9:24 AM