Filter
Top Products
Useful Information
218 For assistance, please visit http://www.panasonic.com/help
Base unit Indicators:
Problem Cause/Solution
The WAN Indicator is
blinking in red.
LThe base unit hardware may be defective.
LUnplug the base unit’s AC adaptor. Reconnect the
adaptor and try again.
LIf this doesn’t resolve the problem, visit
http://www.panasonic.com/help
Then enter model no. KX-WP1050.
The WAN Indicator is
blinking in amber.
LThe base unit firmware may be defective and requires
an update firmware (page 199).
The WAN Indicator is
amber.
LAn Internet connection has not yet to be established.
LCheck the Internet connection settings.
LCheck that you are required to register MAC address
(page 150).
LWhen you change the Internet connection device from
your existing router to the base unit, it may take time to
connect.
The WAN Indicator
alternately flashes in
amber and green in turn.
LThe networks on the WAN side and the LAN side
overlap. Change the LAN side network settings
(“Temporary LAN Side Network Setting when networks
on the WAN side and the LAN side overlap” on page
196).
The WAN Indicator
flashes as a short blinking
in amber and a long flash
in green in turn.
LLAN side network setting is changed temporarily
(“Temporary LAN Side Network Setting when networks
on the WAN side and the LAN side overlap” on page
196).
The WAN Indicator is off. In the hotel room:
LCheck that the base unit and the Ethernet port (RJ45
jack) in the hotel room are connected properly.
LCheck that the power of the base unit is turned on.
At home:
LCheck that the base unit and your device (modem,
existing router or modem with a build-in router) are
connected properly.
LCheck that the power of the base unit and your device
are turned on.
WP1050.book Page 218 Wednesday, November 22, 2006 9:24 AM