Filter
Top Products
68 Operator services
To receive a second call, you must have deactivated the
Call forward for voice calls (see page 60) and
activated the Call waiting (see page 61).
While in communication and one call being on hold,
you may receive a third call. You can either end one of
the calls before being able to answer the third one or
introduce the calling party into a conference (see
below). This service is limited to two current
communications (one active and one on hold).
You activate the conference call by
making several outgoing calls, or create
it from a multiparty call context. You
may have up to five members at the same time and
end all calls at once with
)
.
Make a first call with someone, then a second one (see
“Make a second call” above). Press
,
and select
Conference. Repeat the process until five members
are connected.
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call and add this member to the
Conference call (if five members are already
connected, you can answer the call, but not add it to
the conference).
The Conf. members options allow you to disconnect
a member of the conference by selecting Remove
party, or select Private call to have a private call with
this member only (other members are put on hold).
You can connect an active call and a call on hold by
selecting the Transfer option. You are disconnected
when the transfer is completed.
This feature is different from the Call forward, which
takes place before you pick up the call (see page 60).
Press
)
To reject the call.
Press
,
To select End call to end the current
call, then answer the incoming call.
Answer a third call
Conference call
Conference
Explicit call transfer
Philips755_GB_4311 255 58342.book Page 68 Jeudi, 14. octobre 2004 7:01 19