Filter
Top Products
SpectraLink 8002 Wireless Telephones Configuration and Administration (SIP)
74 PN: 1725-36034-001_C.doc
The display has the following layout for “single ESSID” mode.
1 1 1 1 11 - 22 33 4 44
1 1 1 1 11 - 22 33 4 44
1 1 1 1 11 - 22 33 4 44
1 1 1 1 11 - 22 33 4 44
A n y Det l
Where:
• 111111 = The last three octets of the on-air MAC address for a
discovered AP.
• 22 = The signal strength for the specified AP.
• 33 = The channel number of the specified AP.
• 444 = The beacon interval configured on the specified AP.
• Any/MyID = Softkey to toggle between “single SSID” and “any
SSID” mode.
• Detl/Smry = Softkey to toggle between the multiple AP
(summary) display, and the single (detail) displays for each AP.
The following screen shows how the display would look when there
are three APs configured with an ESSID that matches that of the
handset. The first has a signal strength of –28 dBm, is configured on
channel 2, with a beacon interval of 100 ms. The second has a signal
strength of –48 dBm, is configured on channel 6, with a beacon
interval of 200 ms. The third has a signal strength of –56 dBm, is
configured on channel 11 with a beacon interval of 100 ms.
a b 7 b c8 - 28 02 1 00
2 a e 5 78 - 48 06 2 00
2 a e 5 96 - 56 11 1 00
A n y Det l
When the “any ESSID” mode is selected, the summary display
contains the first six characters of the AP’s ESSID instead of the
beacon interval as in the example below. Also, the number of octets of
the APs BSSID is reduced to 2 octets.