Filter
Top Products
138
• Access name
: edit the access point name.
• Auth type
: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
• User ID
: enter the User ID required to connect to the network.
• Password
: enter the user password required to connect to
the network.
•Protocol
: set the connection protocol used by the WAP browser: WAP,
HTTP, or Other.
•Home URL
: enter the URL address of the page to use as
your homepage.
• Proxy Address
: This option only appears when the Protocol is set to
HTTP.
•
Gateway Address
: Enter the Gateway Address. This option only
appears when the Protocol is set to WAP.
•
Secure connection
: Select
On
or
Off
depending on whether or not
you have a secure connection. This option only appears when the
Protocol is set to WAP.
• Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there is no new data traffic.
• Advanced
: allows you to configure some of the IP-specific information:
Static IP, Static DNS, Server information, and Traffic Class. Highlight
this option and press the Edit soft key to access the following options:
–
Static IP
: specify if you want to manually enter an IP address. Remove the
check mark if you want the server to automatically assign the IP address.
–
Local Phone IP
: allows you to configure the local phone IP address.
–
Static DNS
: specify if you want to manually enter the Domain Name Server
(DNS) address. Remove the check mark if you want the server to
automatically assign the address.