Filter
Top Products
23
To make a call while you have a call in progress:
1. Place the active call on hold using the previous procedures, and enter the
phone number that you wish to dial or look it up in the Address Book.
2. Press the key to dial the second call.
When you have an active call and a call on hold, you may switch between
the two calls, changing the one on hold to active and placing the other on
hold. To switch between the two calls, simply press the Swap soft key.
The current call is placed on hold and the call on hold is reactivated so that
you can continue conversing with that person.
In Call Options
During a call, press the Options soft key to access the following:
• Speaker On: allows you to enable the speakerphone option. The speakersphone is
toggled On/Off by use of the key.
• Whisper On: alllows you to enable the whisper mode. Whisper mode increases the
sensitivity of the microphone so that you do not need to speak above a whisper to
be heard (like in a theater).
• Menu: allows you to access the Main Menu while on a call.
• Mute: allows you to mute the voice microphone. Used if you are on a call and wish
to speak to another party without the person on the other end of the line hearing
you.
• Mute Keys: Silences the key tones when on the call.
• Send DTMF: Sends DTMF (Dual Tone Multi-Frequency) tones to the contacts you
have selected.
• Address Book: access the Address Book information.
Multi-Party Calls
This phone supports multi-party calls. A multi-party call is one of two situations: you
place one call on hold and answer a second call when notified by a call waiting tone,
or where you answer multiple calls and join them (provider-dependent). The
following options then display with the in call options, under the Options left soft
key:
• Join: joins the calls you have established with your phone into a multi-party call.
(provider-dependent)
• Transfer: transfers an incoming call to another number, if supported by your
service provider and set up in your phone settings.
• End Held Call: allows you to end the call on hold.