Filter
Top Products
6564
Dialing numbers from
your Internal Phone Book
Dialing nu m b e rs from your Internal Phone Book is quick
and easy.T h e re are fi v e methods explained below.
Shortcuts to Memory Dialing
S c r oll to the nu m b e r : From Standby mode,slide the
key up or down to enter yo u r
I n t e rnal Phone Book list.S c roll until
you find the desired person or nu m-
b e r,and then press the key.
O n e - To u c h Dialing: P ress and hold the associated digi t
key for the location (applies to mem-
o ry locations 1 through 9).
Two - To u c h Dialing: P ress and release the fi rst associated
d i git key, and then press and hold
the second digit key (applies to
m e m o ry locations 10 through 99).
T h re e - To u c h Dialing: P ress and release the fi rst associated
d i git key, then press and release the
second digit key,then press and hold
the third digit key (applies to memo-
ry locations 100 through 249).
Four Digit Dialing *: From the Standby mode,enter fo u r
c o n s e c u t i ve digits of a stored nu m-
ber (for ex a m p l e ,the last four digi t s
of a number) and press .
Speed Dialing: From Standby mode,enter the nu m-
ber of the memory location,a n d
p ress .
* This fe a t u re that are not supported by your netwo rk oper-
ator may not be ava i l abl e .
Erasing Internal Phone Book entries
To erase an entry in the Internal Phone Book:
1 . From Standby mode,find the Internal Phone Book entry
that you want to ch a n ge by sliding the key up and
then scrolling to the name.
2 . P ress the key to display the name and nu m b e r.
3 . P ress the key for options.
4 . P ress for Era s e .
5 .
P r ess to era s e .Your phone will prompt you for confi rm a-
t i o n .P ress to confi rm and erase the Internal Phone Book
e n t ry,or press to cancel the erase and re t u rn to the
I n t e rnal Phone Book options menu .
The “ E ra s e d ”n o t i fication displays along with the name,nu m -
b e r,and location of the erased entry.
Erasing the Internal Phone Book
See “ E rasing Your Internal Phone Book”on page 87.
Set Speed Dial
For each name entered in the Internal Phone Book,one of
the pro grammed nu m b e rs should be designated as the speed
dial nu m b e r.
1 . From Standby mode,find the number that you want to
ch a n ge by sliding the key dow n and then scrolling to
the name.
2 . P ress the key to display the name and nu m b e r.
3 . P ress the key for options.
4 . P ress for Edit.
5 . P ress for Set Speed Dial.
6 . P ress to Set Speed Dial.The message “Speed Dial
S ave d ”d i s p l ay s .To cancel press to re t u rn to the pre-
vious menu .