Sanyo SCP-6400 Cell Phone User Manual


 
Displaying Your Phone Number
Just in case you forget your phone number, your PCS Phone can
remind you.
To display your phone number:
1. From the Standby mode, press to display the main menu.
2. Highlight Phone Info and press .
3. Highlight My Phone# and press .
Making and Answering Calls
Making Calls
Your PCS Phone offers many different ways to make calls, including
PCS Voice Command
SM
(pages 167-169), Speed Dialing (pages 88-89) and
using Call History (pages 69-73).
To make a call using your keypad:
1. Make sure your phone is on.
2. Enter a phone number. (If you make a mistake while dialing,
press to erase one digit at a time. Press and hold to erase
the entire number.)
3. Press (To make a call when you are roaming and Call Guard is
enabled, press , highlight
Roam Call and press .)
4. When you’re finished, press .
Tip: To redial your last outgoing call, press twice.
Tip: When making calls off the enhanced Sprint Nationwide PCS
Network, always dial using 11 digits (1 + area code + phone number).
Charging the Battery
Your PCS Phone comes with a rechargeable battery. You should charge the
battery as soon as possible so you can begin using your phone.
Keeping track of your battery’s charge is important. If your battery level
becomes too low, your phone automatically turns off and you will lose all
the information you were just working on. For a quick check of your
phone’s battery level, glance at the battery charge indicator located in the
upper-right corner of your phone’s display screen. If the battery charge is
getting too low, the battery icon appears and the phone sounds a
warning tone.
Always use a Sprint-approved desktop charger, travel charger or vehicle
power adapter to charge your battery.
Warning! Using the wrong battery charger could cause damage to your
phone and void the warranty.
Using the Travel Charger
To use the travel charger provided with your phone:
Use only an approved charger with your phone.
1. Plug the Travel Charger into a wall outlet.
2. Plug the other end into the Travel Charger into the bottom of your
phone, with the battery installed.
Charging when your phone is turned on:
The battery icon appears on the display while charging.
The battery icon turns to when charging is complete.
Charging when your phone is turned off:
The battery icon appears, and the message “BATTERY
CHARGING-Power Off-” is shown on the display while charging.
When the battery is completely discharged, you may wait for several
minutes until the message is shown on the display. The battery icon
turns to , and message changes to “CHARGING COMPLETE-
Power Off-” when charging complete.
It takes approximately 3.0 hours to fully recharge a completely rundown
battery. With the Sprint-approved LiIon battery, it is okay to recharge the
battery before it becomes completely run down.
Section 2: Understanding Your Phone
20 2A: Your PCS Phone The Basics
Section 2: Understanding Your Phone
2A: Your PCS Phone The Basics 21