UTStarcom CDM-105 Cell Phone User Manual


 
Section 4A: Safety 161
handset on your body, use the Sprint supplied or approved carrying
case, holster or other body-worn accessory. If you do not use a body-
worn accessory, ensure the antenna is at least 7/16 inch (1.5
centimeters) from your body when transmitting. Use of non-Sprint
approved accessories may violate FCC RF exposure guidelines. For
more information about RF exposure, visit the FCC Website at
www
.fcc.gov.
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy
absorbed in the head of a user of a wireless handset.
The SAR value of a phone is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the phone
emits. All phone models are tested at their highest value in strict
laboratory settings. But when in operation, the SAR of a phone can be
substantially less than the level reported to the FCC. This is because of a
variety of factors including its proximity to a base station antenna,
phone design and other factors. What is important to remember is that
each phone meets strict federal guidelines. Variations in SARs do not
represent a variation in safety.
All phones must meet the federal standard, which incorporates a
substantial margin of safety. As stated above, variations in SAR values
between different model phones do not mean variations in safety. SAR
values at or below the federal standard of 1.6 W/kg are considered safe
for use by the public.
The highest reported SAR values of the
CDM-105
are:
AMPS mode (Part 22):
Head: 1.37 W/kg; Body-worn: 0.777 W/kg
Sprint PCS mode (Part 24):
Head:
1.06
W/kg;Body-worn:
0.412
W/kg
FCC Radiofrequency Emission
This phone meets the FCC Radiofrequency Emission Guidelines.
FCC ID number:
O6YUTS-C2000
.
Safety
160 Section 4A: Safety
To ensure the minimum interference for the Keypad backlight, follow
these steps:
1. Press Menu ( ) to access the main menu.
2. Select Settings().
3. Select Display().
4. Select Backlight().
5. Select Keypad.
6. Scroll and select the minimum time interval setting (8 seconds).
7. Press Select ( ) to assign the desired option.
Acknowledging Special Precautions
and the FCC Notice
FCC Notice
This phone may cause TV or radio interference if used in close
proximity to receiving equipment. The FCC can require you to stop
using the phone if such interference cannot be eliminated.
Vehicles using liquefied petroleum gas (propane or butane) must
comply with the National Fire Protection Standard (NFPA-58). For a
copy of this standard, contact the National Fire Protections Association,
One Batterymarch Park, Quincy, MA 02269, Attn.: Publication Sales
Division.
Cautions
Any changes or modifications to your phone not expressly approved in
this document could void your warranty for this equipment and void
your authority to operate this equipment. Only use approved batteries,
antennas and chargers. The use of any unauthorized accessories may be
dangerous and void the phone warranty if said accessories cause
damage or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment
and can be broken. Avoid dropping, hitting, bending or sitting on it.
Body-Worn Operation
To maintain compliance with FCC RF exposure guidelines, if you wear a