Filter
Top Products
SETUP
Installing SIM, SAM, and SD Cards
16 NURIT 8000 INSTALLATION GUIDE
7 Lower the SIM/SAM cardholder onto its base.
Check that the corner of the SIM/SAM card is not obstructed by the triangular
protrusion at the corner of the cardholder base.
8 Lock the SAM cardholder by sliding the cardholder locking clasp to the LOCK
position.
9 If necessary, replace the battery. See Figure 9.
10 Replace the battery/card compartment cover. See Figure 5.
Figure 6 Installing and Removing a SIM/SAM Card
To remove a SIM/SAM
card
1 Open the card holder, by following steps 1-4 of To install a SIM or a SAM card
and remove the card.
2 Close the card holder by following steps 7-8 of To install a SIM or a SAM
card.
For further instructions, see Figure 6.
To install an SD/MMC
card
1 Remove the battery/card compartment door. See Figure 4.
2 If necessary, remove the battery. See Figure 10.
3 Hold the SD/MMC card directly above the SD/MMC card slot, with the metal
contacts facing down and the narrow edge with the beveled corner pointing
towards the slot opening.
4 Lower the SD/MMC card into position.
CAUTION
Do not bend or scratch the contacts of the SAM cardholder when installing or
removing cards.