Filter
Top Products
SETUP
Connecting the Battery
18 NURIT 8000 INSTALLATION GUIDE
Connecting the
Battery
The NURIT 8000 terminal comes with a Lithium-polymer battery. Read this
section to know how to install and remove the battery.
Depending on your model of the NURIT 8000 terminal, the battery compartment
may be shared with the SIM, SAM, and SD cards. To gain access to the battery/
card compartment, you must first remove the battery/card compartment door. For
information on removing and replacing the battery/card compartment cover, see
Opening and Closing Battery/Card Compartment Cover.
Connecting and
Removing the
Battery
The NURIT 8000 allows you to operate the terminal without an external power
supply, by using a battery.
To insert the battery
1 Remove the battery/card compartment cover. See Figure 4.
2 Hold the battery, verifying that the side with the metal contacts are facing
downwards and that the rounded edge is facing towards the back of the
compartment.
3 While holding the battery at a 30° angle, slide the two tabs on the front of the
battery into the slots on the front wall of the compartment.
4 Push the back of the battery down, until it snaps into place.
Figure 9 Inserting the Battery
5 Replace the battery/card compartment cover. See Figure 5.
To remove the battery
1 Power off the terminal. See Powering On and Off the Terminal With a Battery
Pack.
2 Remove the battery/card compartment cover. See Figure 4.
3 Insert your fingernail into the groove at the back of the battery and lift the
battery, snapping the battery out of place.
NOTE
Only use batteries provided by VeriFone. For information about purchasing
additional or replacement batteries, see Accessories and Documentation.