Filter
Top Products
Radio Frequency (RF) Energy
44 45
While there may be differences between the SAR levels
of various devices and at various positions, they all
meet the government requirement.
The FCC has granted an Equipment Authorization for
this model device with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines.
SAR information on this model device is on file with the
FCC and can be found under the Display Grant section
of http://www.fcc.gov/oet/fccid after searching on:
• FCC ID: Q78-Z221.
• For body worn operation, this phone has been
tested and meets the FCC RF exposure guidelines
for use with an accessory that contains no metal and
positions the handset a minimum of 1.5 cm from the
body. Use of other enhancements may not ensure
compliance with FCC RF exposure guideline.
This model device meets the government’s requirements
for exposure to radio waves.
This device is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission
of the U.S. Government.
The exposure standard for wireless devices employs a
unit of measurement known as the Specific Absorption
Rate or SAR. The SAR limit set by the FCC is 1.6W/kg.*
Tests for SAR are conducted using standard operating
positions accepted by the FCC with the device
transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined
at the highest certified power level, the actual SAR level
of the device while operating can be well below the
maximum value. This is because the device is designed
to operate at multiple power levels so as to use only
the power required to reach the network. In general,
the closer you are to a wireless base station antenna,
the lower the power output.
The highest SAR value for the model phone as
reported to the FCC when tested for use at the
ear is 0.622 W/kg and when worn on the body,
as described in this user guide, is 0.667 W/kg.
(Body-worn measurements differ among phone
models, depending upon available accessories
and FCC requirements.)
* In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram
of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any
variations in measurements.
FCC Compliance
This mobile phone complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received,
including interference that may cause undesired
operation.
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment to an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• Changes or modications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
The antenna(s) used for this transmitter must not be
co-located or operating in conjunction with any other
antenna or transmitter.