Configuring the Projector 59
■ Operation Lock
In Full Lock mode, disables all of the projector’s buttons,
including the P Power button. In
Partial Lock mode,
disables all of the projector’s buttons except the P Power
button. Changes to this setting take effect after you restart the
projector. (After you turn off the projector, wait for the
P Power light to turn solid orange before turning it
on again.)
■ Pointer Shape
Lets you select from three different pointer shapes. The
Password Protect function must be cancelled first. See
page 70.
■ Brightness Control
Allows you to select Low lamp brightness when the
projection is too bright for the room. The Low setting also
reduces electricity consumption and fan noise. Select
High
to project at the maximum brightness. (Also check the
Brightness setting in the Image menu; see page 55.)
■ Volume
Adjusts the volume for the projector’s speaker or an audio
system connected to the projector.
■ RCA Audio Input
Lets you change the L-Audio-R audio port as the input for
the Video port or S-Video port. Select
Video to use the RCA
port for the Video port. Select
S-Video to use the RCA port
for the S-Video port.
■ Remote Receiver
Select Off to disable the remote control receivers on the
projector to prevent interference from fluorescent lighting or
other sources. Or enable specific receivers using the following
settings:
Front/Rear, Front, or Rear.
■ Test Pattern
Allows you to adjust the projector without a video source.
While the test pattern is displayed, you can make Zoom,
Focus, and Keystone adjustments.
3. When you’re finished, press
Esc or Menu.
note
To cancel the Operation
Lock function from the
projector, press the
Enter
button for about seven
seconds.
