78 Monitoring the Projector Over a Network
■ Address 1/2/3 Setting
Choose one of the Address Setting fields, then enter the
e-mail address where you want to receive a message when a
problem occurs.
4. When you’re done, press
Menu to exit the menu system.
When a problem occurs, an e-mail message is sent to the specified
addresses with the subject line
EPSON Projector and the following
information:
■ Line 1: The name of the projector where the problem has
occurred
■ Line 2: The IP address of the projector where the problem has
occurred
■ Line 3: Details of the problem
Using EMP Monitor
EMP Monitor lets you use a remote computer to manage your
projectors. It lets you easily turn them on or off (together or
individually), switch image sources, and check on their status.
Before using EMP Monitor, make sure you’ve installed the software
(available for Windows only) as described on page 74. The computer
you’re using to monitor the projector should already be connected to
your network.
Opening and Closing EMP Monitor
To start EMP Monitor, click Start > Programs or All Programs >
EPSON Projector > EMP Monitor
.
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
