Indicator Cause Remedy or Status Status Monitor Dis‐
play
Power Status Lamp1/
Lamp2
Temp Filter
Off Blue -
Flashing
Off
Orange -
Flashing
Off
Cool System Error Stop using the projector, remove the power cord from the electrical outlet, and
contact your local dealer or the nearest address provided in the Epson Projector
Contact List.
s Epson Projector Contact List
Pump Error
Off Blue -
Flashing
Orange -
On
Off Off
Lamp Error
Lamp Failure
Check the following points.
• Remove the lamps and check if they are cracked.
s "Replacing the Lamp" p.175
• Clean the air filter.
s "Cleaning the Air Filter" p.172
Lamp1 Error (S)
Lamp1 Error (P)
Lamp2 Error (S)
Lamp2 Error (P)
Lamp1 Failure (S)
Lamp1 Failure (P)
Lamp2 Failure (S)
Lamp2 Failure (P)
If the lamps are not cracked: Attach the lamps again and turn on the power.
If the error continues: Replace the lamps with new ones and then turn on the
power.
If the error continues: Stop using the projector, remove the power cord from
the electrical outlet, and contact your local dealer or the nearest address
provided in the Epson Projector Contact List.
s
Epson Projector Contact List
If the lamp is cracked: Contact your local dealer or the addresses on the Epson
Projector Contact List for further advice. (If one of the lamps cracks, only the
other lamp is used. Replace the lamp as soon as you can.)
s
Epson Projector Contact List
When using at an altitude of 1,500 m or more, set High Altitude Mode to On.
s Extended - Operation - High Altitude Mode p.122
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down
when the projector is installed in a direction which is not horizontal.
s
Extended - Direction p.122
Reading the Indicators
144
