5-136
136 | Maintaining and Transporting the Printer
Changing the Date and Time
1. Press the Menu button.
2. Press the d button until
MAINTENANCE is highlighted, then press
Menu.
3. Press the d button until you see
CLOCK SETTINGS, then press Menu.
4. Use the d and u buttons and the Menu button to set each item in the
date and time, displayed in the following format:
MM/DD/YY HH:MM.
5. Press to save the setting.
Using Maintenance Mode
Maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use
maintenance mode to do the following:
• Print a hex dump for diagnosing problems
• Change the language or units of measurements used on the printer’s
control panel menus
• Enable the printable pages counter
• Change the default pressure setting for the automatic cutter
• Run a “super strong” cleaning cycle.
• Track the amount of roll paper remaining
• Enable power on roll paper feed
• Return all of the printer’s control panel settings to their default values
• Check ink information
Note: You can use the
PRINTER SETUP menu to
enable the roll paper
counter, paper size
check, and several other
printer features. For more
information, see your
electronic Reference
Guide.
7800-9800Guide.book Page 136 Monday, April 10, 2006 11:59 AM
