A SERVICE OF

logo

1-24
24 | Setting Up the Printer
4. Fasten the printer to the stand with the wing screws and washers.
5. Remove any packing tape. Check these areas:
the front cover
the ink compartment covers
the maintenance tank (on the right side near the bottom)
6. Open the front cover. Follow the red wire to locate the bolt and bracket
securing the print head. Then unscrew the bolt and remove the bracket
as shown.
Save the bolt and bracket in case you need to ship the printer.
Note: To prevent paper
jams, don’t place the bolt
back in the printer.
7800-9800Guide.book Page 24 Monday, April 10, 2006 11:59 AM