24 MS6000-EU-EN V1.4 8/12
3. Each option in HORI MENU is described as follows:
Options Settings Comments
Window Control (F1)
(Menu page 1)
Double Window
Single Window
Selects either Single or Double window mode (see figures
below table). Press this option button in single-window
mode to enter the dual-window mode.
Window Selection (F2)
(menu page 1)
Major Window
Minor Window
Selects the major (upper) or minor (lower) window in
dual-window mode. The window is highlighted once
selected.
Holdoff (F3)
(menu page 1)
Select this menu and click the up and down Arrow keys to
adjust the trigger hold-off time within the range of
100ns-10s.
Reset (F4)
(menu page 1)
Page (F5) Change Menu pages 1 to 3 when Window Control is set to
Double Window
Pre Mark (F2)
(menu page 2)
Used when Marks are set in place. This button will position
the display to view the signal at any marks to the Left of your
present view.
Next Mark (F3)
(menu page 2)
Used when Marks are set in place. This button will position
the display to view the signal at any marks to the Right of
your present view.
Set/Clear (F4)
(menu page 2)
Sets a mark or Clears the indicated mark. To place a Mark
on the signal, place that portion of the signal to be observed
at the center verticle line (Bottom window) using the
Horizontal Position button. Press the Set button to add or
remove that mark.
Clear All (F2)
(menu page 3)
Clear all Marks
Play/Stop (F3)
(menu page 3)
Push this button to auto move the signal from left to right.
Set the signal window to the left most position using the
Horizontal position button. Press Play to start the signal
moving across the screen. Press Stop to halt the
movement.
