A SERVICE OF

logo

Open as PDF
next previous
71 MS6000-EU-EN V1.4 8/12
Taking a Relative Measurement
A relative measurement is a measurement taken and compared to a stored reference value.
The resultant display represents the measurement minus the reference value.
The following example illustrates the relative measurement process. The first step is
to store a reference value.
1) Press the ‘Ω’ key.
2) Insert the black lead into the COM banana jack input and the red lead into the V/Ω/C
banana jack input.
3) Connect the red and black test leads to a resistor. The resistance value is shown on the
screen in Ohms.
4) When the reading stabilizes, press the F1 key; the ||/is displayed on the top of the
screen.
The saved reference value is displayed.
The screen will resemble the image shown in figure 7-12.
Figure 7-12 Relative Measurement
Manual
Manual