74 MS6000-EU-EN V1.4 8/12
Chapter 7 - Specifications
7.1 Technical Specifications
All published specifications apply to the MS6000 series oscilloscopes. Before checking an
oscilloscope to verify its compliance with these specifications, ensure that the oscilloscope
meets the following conditions:
The oscilloscope must have undergone a twenty minute warm-up period under the
specified operating temperature.
The ‘Do Self Cal’ operation must be performed through the Utility menu if the operating
temperature changes by more than 5
o
C.
The oscilloscope must be within the factory calibration interval.
All specifications are guaranteed unless noted ‘typical’.
Oscilloscope Specifications
Horizontal
Sample Rate Range 1GS/s
Waveform Interpolation (sin x)/x
Record Length
Maximum 1M samples per single-channel; maximum 512K
samples per dual-channel
MS6060
MS6100
MS6200
TIME/DIV Range
4ns/div to 40s/div, in a 2, 4, 8
sequence
2ns/div to 40s/div, in a 2, 4, 8
sequence
Sample Rate and
Delay Time Accuracy
±50ppm over any ≥1ms time interval
