A SERVICE OF

logo

72 MS6000-EU-EN V1.4 8/12
Selecting Automatic/Manual Range Adjustment
The default mode is the automatic range mode. For example: In the DC voltage mode,
to switch to the manual range, perform the following steps:
1) Press F3 to enter the manual range mode; the Manual icon is displayed.
2) In the manual range mode, the measuring range is increased each time the F4 is pressed.
When the highest range is reached, the next F4 key press moves the meter to the lowest
range.
3) Press F3 to revert to the automatic range mode; the Auto icon is displayed again.
Attention: Capacitance measurements cannot be made in the manual range mode.
The screen will resemble the image shown in figure 7-13.
Figure 7-13 Manual Range Mode
Manual DC
Manual