- 177 -
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent
when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing terminal interface
session.
Syntax
snmp-server enable traps multiusers
no snmp-server enable traps multiusers
no - This command disables Multiple User trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables OSPF traps.
Syntax
snmp-server enable traps ospf {all | errors {all | authentication-failure | bad-packet | config-error |
virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all | lsa-maxage
| lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change | neighbor-state-change |
virtif-statechange | virtneighbor-state-change}}
no snmp-server enable traps ospf {all | errors {all | authentication-failure | bad-packet | config-error |
virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all | lsa-maxage
| lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets |
virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change | neighbor-state-change |
virtif-statechange | virtneighbor-state-change}}
no - This command disables OSPF trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables OSPFv3 traps.
Syntax
snmp-server enable traps ospfv3 {all | errors {all | authentication-failure | bad-packet | config-error |
-
-
-
-
-
-
-
-
-
